DSC PC1150 Installation Manual download pdf (Page 26)

[30]

Reset to Factory Default

Software Reset

Entering Section

[30]

will reset the control panel’s programming to the default settings. When Section

[30]

entered, the keypad will beep several times and the “Trouble” light will come ON during the reset sequence.

Hardware Reset

If the Installer’s Code

forgotten and

software reset cannot be performed, the panel may be reset to the default

settings with the following method:

f3fl

Remove all power, AC and battery, from the panel

Short the pins marked EEPROM RESET

While maintaining theshort, power-up the panel and wait

forat

least 10 seconds before removing the short

After at least 10 seconds, remove the short. The keypad buzzer will beep and the panel’s programming

will be reset to the default settings

4th System Option Code

Refer to Section

[12]

for programming instructions.

LIGHT

[II

ON =

Able to answer call from downloading computer

l OFF

Cannot answer call from downloading computer

ON =

Enable callback to downloading computer

. OFF =

Disable callback to downloading computer

[31

ON =

Enable answering machine over-ride

l OFF = Disable answering machine over-ride

[41

ON =

‘System” light flashes when armed to indicate alarm memory

l OFF = “System” light normal

[RI

ON =

Quick-Arm enabled

l OFF = Quick-Arm disabled

[Al

Restore on siren time-out (if zone is restored)

l OFF = Restore as follower (when zone restores)

[R] = ‘Ready” light; [A] = “Armed” light

l Factory default

Downloading and Answering Machines

The answering machine override feature allows an answering machine to be connected to the same telephone

line as the control panel. Turn Light

[3]

in Section

[31]

ON to enable this feature.

To access the panel, have the downloading computer call the control panel and let the line ring for 1 or 2 rings

only. Hang up the line and then call the panel back within the time programmed in Section

[33];

the panel will

then answer the second call on the first ring.

If Light

[3]

is OFF, it is assumed that there is no answering machine connected to the telephone line, and the

panel will capture the line after the set number of rings.

Note that if Light

[3]

is OFF and an answering machine is connected to the line and is set to answer before the

panel, the panel will be unable to receive a call from the downloading computer.

If the panel is set to answer

before the answering machine, the answering machine will be unable to receive incoming calls.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 37 38

Comments to this Manuals

No comments

DSC PC1150 Installation Manual Page 26

Comments to this Manuals

Related products and manuals for Security access control systems DSC PC1150