DSC PC1150 Installation Manual download pdf (Page 21)

1143

3rd System Option Code

Refer to Section

[12]

for programming information.

LIGHT

111

ON =

Access code required for bypass

l OFF =

Access code not required for bypass

ON =

Enable

[*][4]

downloading call feature

l OFF

Disable

[*][4]

call feature’

131

ON = Periodic

downloading2

l OFF = Periodic test transmission

141

ON =

[*][4]

requires a Access Code

l OFF

[*][4]

does not require Access Code

[RI

l ON

[*][#I

Panic Alarm has keypad-audible feedback

OFF =

[*][#I

Panic Alarm does not have keypad-audible feedback

Partial closings identified

. OFF =

Partial closings not identified

[R] = “Ready” light; [A] = “Armed” light

l Factory default settings

[*][4]

allows downloading to be initiated from the control panel

The panel can be programmed to periodically call the downloading computer. The cycle time in days for

the call is set in Section

[19].

The automatic call to the downloading computer can be used to update the

panel program and/or to upload status information from the panel.

If partial closings to be identified, alarm codes for bypassed zones will be transmitted.

[15]

Communication Variables

Enter a

2-digit

number in this Section. This number defines the number of attempts the communicator will make

to transmit alarm and

restoral

reports

for a zone before the communicator shuts down for that zone. The number

of attempts is for the period defined in Section

[12],

1st System Option Code, Light 2. The number of

communication attempts may be programmed from [00] to

[99],

where ‘00’ means the communicator will never

shut down. Note that the fire zone cannot be shut down; it always transmits.

[16l

Zone Bypass Mask

Refer to Section

[12]

for programming information. If a zone light is ON, that zone can be bypassed; if a zone light

is OFF, that zone cannot be bypassed using the

[*][l]

command. Note that the fire zone cannot be bypassed.

[I71

System limes

Six system times are programmed in Section

[17];

each time requires a 2-digit number. Do not press the

[#]

Key during data entry.

[31

[41

Entry Delay

(01 to 99 seconds) Location [I] holds the standard Entry Delay time. The default setting is

30 seconds; refer to Section

for information on Zone Definitions.

Exit Delay

(01 to 99 seconds) Location

[2]

holds the standard Exit Delay time. The default setting is 45

seconds; refer to Section

for information on Zone Definitions.

Siren Cut-Off

(01 to 99 minutes) Location

[3]

determines how long the siren will sound when an alarm is

generated. The default setting is 4 minutes.

AC Failure Transmission Delay (01

to 99 minutes) Location

[4]

determines the length of time before the

communicator will transmit an AC failure report. The default setting is 30 minutes.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 37 38

Comments to this Manuals

No comments

DSC PC1150 Installation Manual Page 21

Comments to this Manuals

Related products and manuals for Security access control systems DSC PC1150