DSC PC1150 Installation Manual download pdf (Page 25)

Strobe Output (Latched Alarm Output)

The PGM switches to ground on an alarm and remains low until the panel is disarmed. It can be used

to indicate that an alarm has occurred before entering the premises.

Failure to Communicate

The PGM output switches to ground if the system fails to communicate after 8 attempts to each phone

number that will be tried according to Section [25] Communicator Call Direction Options. The output

remains low until a successful communication takes place or until the Unsuccessful Communication

Attempt trouble is cleared. This option can be used to link two systems together so that if one fails to

communicate, the other system will report the failure.

~251

Communicator Call Directions

Section [25] determines how the communicator will call the telephone numbers programmed in Sections

[Ol]

and [03] to report the following events:

l Zone Alarms and Restorals

l Access Codes Openings and Closings

l Priority Alarms and Restorals

l Maintenance Alarms and Restorals

Enter one digit from the list below for each of the reporting groups. The default setting is [I] for all groups.

[0] No transmission

[1]

Call 1st phone number and back-up to the 2nd phone number when Section [13] Light 1 is OFFand the

panel has made 8 unsuccessful attempts on the 1st phone number.

[2] Call the 2nd phone number only

[3] Always call both phone numbers

NOTE: If the [#] Key is pressed during data entry, the keypad will return to the Installer’s Programming Mode

and any data entered in this section will not be saved.

[2g]

Downloading Telephone Number

Enter the Downloading Telephone Number in this section. This telephone number is dialled during automatic

downloading or when downloading is requested with the

[$][4]

command. RefertoSection

4],3rd

System Option

Code, Lights 2and 3.

Referto

Section

[Ol]

1st Phone

Number

for

instructionson programming telephone numbers.

1271

Downloading Access Code

This 4-digit code allows the panel to confirm that it is communicating with the intended downloading computer.

Enter 4 digits using the numbers 0 through 9 only. The default code is [1515].

[281

Panel Identification Code

This 4-digit code allows the downloading computer to confirm the identity of the control panel. Enter 4 digits

using the number keys 0 through 9 only. The default code is [1501].

I291

Number of Rings Sefore Answering

Section [29] sets the number of rings before the panel will pick-up the line and answer the call.

Refer to Section

[31]

for information on using the system with an answering machine connected to the same phone line.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 37 38

Comments to this Manuals

No comments

DSC PC1150 Installation Manual Page 25

Comments to this Manuals

Related products and manuals for Security access control systems DSC PC1150