DSC PC1150 Installation Manual download pdf (Page 17)

3/f

format

Non-extencfed

reporting

Requires:

l 3-digit account code in sections

[02]

1041.

For example, enter 1230 for account code 123

l Format Code [0],

[l],

[2],

[3],

[4]

depending on receiver type in section

[23].

Single line digit Alarm Reporting Code Section

[05].

For example, enter

[30]

for

single digit code 3 (0 = no pulses)

TRANSMISSION SENT: 123 3

4/2

Format

Non-extended reporting

Requires:

l 4-digit account code in sections

[02]

[04].

For example, enter 1230 for account code 123

l Format Code [0],

[l],

[23,

[3],

[4]

depending on receiver type in section

[23].

2-digit

Alarm Reporting Code in section

[05].

For example, enter

[31]

for 2-digit code 31

TRANSMISSION SENT: 1234 31

3/l

Format

Extended reporting

Requires:

3-digit

Account Code in section

[02]

[04].

For example, enter 1230 for code 123

Format Code

[8],

[9],

[A],

[B],

[C] depending on receiver type in section

[23]

2-digit

Alarm Reporting Code in section

[05].

For example, enter

[31]

for 2-digit code 31

TRANSMISSION SENT: 1

st ROUND

123 3

2nd ROUND 333 1

If a transmission is not needed for a particular reporting code, enter [00] or [FF] to disable that reporting code.

[06]

Zone

Restoral

Reporting Codes

Zone

Restoral

Codes are transmitted when zones 1 through 6 are restored from an alarm condition. Refer to

Section

[05]

for programming instructions.

1071

Closing

(Arming) Reporting Codes

Partial

Closing

Reporting Code

Closing Reporting Codes are transmitted to

identify

arming of the system

Access Codes 1 through 6.

If Partial

Closing is identified in Section

[14],

the alarm codes for manually bypassed zones will be transmitted when the

system is armed with one or more zones bypassed. Refer to Section

[05]

for programming instructions. The

Closing Reporting Codes may be programmed as follows:

P31

K41

The first digit, HEX ‘C’, represents “closing”, and the second digit represents the Access Code which was used

to arm the system. Note that any number or HEX digit may be used for the first digit; check with the intended

monitoring station to determine their reporting code preferences.

The Closing Code transmission takes place after the Exit Delay. If the system is

armed

and then disarmed before

the Exit Delay expires, no closing transmission will take place.

The partial closing code, if used, is transmitted with the regular closing code to identify a partial closing.

When the system has been armed using the

[*][O]

Quick-Arm command or the Auto-Arm feature,

Access Code 1 will be transmitted.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Comments to this Manuals

No comments

DSC PC1150 Installation Manual Page 17

Comments to this Manuals

Related products and manuals for Security access control systems DSC PC1150