DSC PC1150 Installation Manual download pdf (Page 6)

INSTALLATION

Mounting

the

Pane/

The keypad should be located close to the designated “Entry-Exit” door and be mounted at a height convenient

for all users. Select a dry location close to an

unswitched

AC source and close to the telephone line connection.

Remove the printed circuit board, the mounting hardware and the keypad from the cardboard packaging.

Assembling The Unit

Fromthespeaker-sideofthemounting bracket, pressthefourwhitenyloncircuit boardmountingstudsintothe holes

provided so that the studs face away from the speaker. If it is not attached, attach the communicator to the control

panel; ensure that all pins on the communicator are inserted into the control panel’s sockets. Align the assembled

unit with the mounting bracket so that the communicator’s ribbon wire aligns with the cut-out on the mounting

bracket. The wiring terminals should be behind the speaker, with the communicator’s terminals facing up. Press

the assembled unit onto the mounting studs.

PRESS ASSEMBLED

CONTROL PANEL ONTO

MOUNTING STUDS

INSERT

MOUTNING

STUDS

INTO BRACKET

Mounting the Enclosure

With the battery box opening facing down, mount the enclosure in a prepared opening in the wall; at least one

side of the metal box should be secured to a wall stud. Place the battery box into the enclosure and secure the

battery box with a screw. Pull all cables into the cabinet and prepare them for connection. Use a meter to test

the wiring for opens, shorts and grounds. Place the battery into the battery box, but do not connect it to the

panel yet. Connect the speaker wires to the BELL terminals (red to

and black to

-);

you may wish to trim the

length of the speaker wires to reduce clutter behind the panel. If the wires are trimmed, ensure that their ends

are properly prepared for connection to the terminals.

Align the grey strip on the communicator’s ribbon wire with the RED terminal on the keypad circuit board plug

and press the ribbon wire into place. Complete all wiring to the control panel before applying AC power or

connecting the battery. With all wiring completed, connect the batteryto the unit. insert the unit into the

enclosure so that the speaker faces out of the unit and is on the left side of the enclosure. Mount the front panel

on the enclosure, and secure with four screws.

NOTE: Complete all wiring to the control panel before applying AC power or connecting the battery.

1 2 3 4 5 6 7 8 9 10 11 ... 37 38

No comments

DSC PC1150 Installation Manual Page 6