DSC PC15OO Installation Manual download pdf (Page 22)

When the urgency option is selected for the audibile Exit

Delay, the keypad will sound a pulsing tone during the Exit

Delay. During the last 10 seconds of the Exit Delay, the

keypad will sound a faster pulsing tone to warn that the delay

is about to expire.

[35] LINKS1000 Test Reporting Code

Cellular communications through the LINKS1000 Cellular

Alarm Transmitter will be tested periodically according to

the test transmission times programmed in Sections [17]

and [19]. The reporting codes programmed in Section

[35] will be transmitted during the cellular transmission

test.

When the cellular test transmission is completed, the

Automatic Test Code programmed in Section [10] will be

transmitted over the regular telephone line.

[36] Keypad Lockout Control

Program two 2-digit numbers in this section.

The first entry determines how many invalid codes may be

entered before the keypad is locked out and will not

accept any further entries. Program a number from 00 to

99; 00 disables the keypad lockout function.

The second entry determines how long, in minutes, the

keypad will be locked out once the programmed

number of invlaid codes are entered. Program a time

from 00 to 99 minutes.

[90] Installer’s Lockout Enable

This feature is enabled by entering [90] while in the installer’s

programming mode. A factory default (hardware or software)

will not reset the installer’s code or the download access

code once this feature is enabled. A panel that has this

feature enabled will give a distinct audible indication upon

power-up. This indication is the phone line relay clicking 10

times. Make sure that your new installer’s code has been

entered correctly before enabling this feature because there

is no way of re-entering the programming mode without the

new installer’s code. Remember that even a reset to the

factory default will not change the installer’s code back to the

default.

[91] Installer’s Lockout Disable

Entering [91] when in the installer’s programming mode will

disable the installer’s lockout feature.

NOTE:

Panels returned to DSC with the installer’s lockout

feature enabled and no other apparent problems will be

subject to an additional service charge.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Comments to this Manuals

No comments

DSC PC15OO Installation Manual Page 22

Comments to this Manuals

Related products and manuals for Security access control systems DSC PC15OO