DSC PTK5507 User Manual download pdf (Page 9)

Disarm

If Disarm is selected:

• A numerical keypad is displayed.

• Enter your Access Code in the keypad.

• The system returns to the Home screen and the red Armed indicator turns OFF.

• The alarm status is momentarily displayed in the status bar, then "Ready" is displayed.

• The green Ready indicator turns ON.

Disarming Error

If your code is invalid, the system will not disarm and a 2-second error tone will sound. If this happens,

press # and try again.

Away Arm

When Away Arm is selected:

• Enter a valid access code to proceed.

• The Armed LED Indicator turns ON.

• "Exit Delay in Progress" is displayed in the Status Bar. The pre-programmed exit delay begins.

• The touchscreen "beeps" at a 1-second urgency interval during the exit delay. Then 3 beeps sound in

the last 10 seconds.

NOTE: If Quick Arm is not enabled by the installer, a numerical keypad is displayed.

If Disarm is selected during the exit delay:

• A numeric keypad is displayed. Tap your access code.

• The Arming sequence is aborted and the system returns to the Home screen.

• The Armed LED turns OFF.

At the end of the pre-programmed exit delay:

• The Disarm screen is displayed.

• The Ready Indicator turns OFF.

• "Away Armed" is displayed in the Status Bar.

Bell/Siren Sounds After Away Arming

Audible Exit Fault

In an attempt to reduce false alarms, the Audible Exit Fault is designed to notify you of an improper exit

when arming the system in the Away mode. In the event that you fail to exit the premises during the

allotted exit delay period, or if you do not securely close the Exit/Entry door, the system will notify you

that it was improperly armed in two ways: the keypad will emit one continuous beep and the bell or

siren will sound.

Your installer will tell you if this feature has been enabled on your system. If this occurs:

1. Re-enter the premises.

2. Enter your access code to disarm the system. You must do this before the entry delay timer

expires.

3. Follow the Away arming procedure again, making sure to close the entry/exit door properly.

Arming Error

An error tone will sound if the system is unable to arm. This will happen if the system is not ready to

arm (i.e., sensors are open), or if an incorrect user code has been entered. If this happens, ensure all sen-

sors are secure. Press [#] and try again, ensuring that a valid access code is entered. Please check with

your installer to determine if arming is inhibited by any other means.

Remote Arming and Disarming

The system can be armed and/or disarmed using the remote wireless key. When arming the system by

using the Arm button on the wireless key, the system will acknowledge the command by sounding a sin-

gle bell squawk (if bell squawk is enabled). When disarming using the Disarm button on the wireless

key, the system will acknowledge the command by sounding two bell squawks (if bell squawk is

enabled) that can be heard from the exterior of the premises.

When Alarm Sounds

The system can generate 4 different alarm sounds:

• Temporal/ pulsed siren = Fire Alarm

• 4 beeps, 5-second pause, 4 beeps = Carbon Monoxide Alarm

• Continuous siren = Intrusion (Burglary Alarm)

NOTE: The priority of signals is fire alarm, carbon monoxide alarm then burglary alarm.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

DSC PTK5507 User Manual Page 9

Comments to this Manuals

Related products and manuals for Security access control systems DSC PTK5507