DSC PTK5507 User Manual download pdf (Page 18)

Partition Assignment Mask ([][5][Master/Supervisor Code][98][Code])

1. Partition One Access (available for PC1616/PC1832/PC1864)

2. Partition Two Access (available for PC1616/PC1832/PC1864)

3. Partition Three Access (available for PC1832/PC1864)

4. Partition Four Access (available for PC1832/PC1864)

5. Partition Five Access (available for PC1864)

6. Partition Six Access (available for PC1864)

7. Partition Seven Access (available for PC1864)

8. Partition Eight Access (available for PC1864)

Notes on Access Codes and Programming

1. The master code’s attributes cannot be changed.

2. When a new code is programmed in User Programming it will be checked against all other codes

in the system. If a duplicate code is found, an error tone is given and the code is returned to what

it was before it was changed. This applies to both 4 and 6-digit codes.

Erasing an Access Code

To erase a code, select the code and choose Delete User. The system will delete the code immediately

and the user will be returned to select another code.

Installer Menu

These functions are for the installer’s use only.

User Functions

First disarm the system then enter Options, User Functions, then Master Code. This command is used to

gain access to the following list of master functions of the system:

Time and Date

Enter desired time and date.

Auto-Arm Time

The system can be programmed to arm at a programmed time each day, per partition. Upon entry of this

section, enter the desired Auto-Arm time for each day of the week.

At the selected Auto-Arm time, the keypad buzzers will sound for a programmed amount of time (pro-

grammable by the installer only) to warn that an auto-arm is in progress. The bell can also be pro-

grammed to squawk once every 10 seconds during this warning period. When the warning period is

complete, the system will arm with no exit delay and in the Away Mode.

Auto-Arming can be cancelled or postponed by entering a valid access code only during the pro-

grammed warning period. Auto-Arming will be attempted at the same time the next day. When the

Auto-Arming process is cancelled or postponed, the Auto-arm Cancellation Reporting Code will be

transmitted (if programmed).

If arming is inhibited by one of the following, the Auto-Arm Cancellation transmission will be commu-

nicated:

• AC / DC Inhibit Arm

• Latching System Tampers

• Zone Expander Supervisory Fault

Enable DLS/Allow System Service

If enabled, the installer will be able to access Installer Programming via remote (DLS). In case of DLS

access this provides a window where rings will be detected by the panel. The DLS window will remain

open for 6 hrs, during which time the installer will be able to enter DLS an unlimited number of times.

After the 6-hr window has expired, Installer’s Programming will be unavailable again until the window

is re-opened.

Event Buffer

Displays the date, time and the full description of the event.

The Log is organized from the most recent event (Top) to past events (Down).

The Left arrow scrolls forward in time.

The Right arrow scrolls back in time.

The Back returns you to the Home screen.

This screen will time out to the Home screen after 30 seconds of inactivity.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Comments to this Manuals

No comments

DSC PTK5507 User Manual Page 18

Comments to this Manuals

Related products and manuals for Security access control systems DSC PTK5507