DSC PowerSeries Self Contained Wireless Alarm System User's Guide download pdf (Page 9)

bypassed when arming your system. Zones cannot be bypassed once the system is armed. Bypassed

zones are automatically cancelled each time the system is disarmed and must be bypassed again, if

required, before the next arming.

Bypassing Zones

With the system disarmed.

1. Press to enter the function menu. The keypad will display “Press  for < > Zone Bypass”.

2. Press or , then your [access code] (if required). The keypad will display “Scroll to < >

Bypass Zones”.

3. Enter the two-digit number of the zone(s) to be bypassed (01-34).

You can also use the keys to find the zone to be bypassed, and then press to select the

zone. The keypad will display “Zone Name”. “B” will appear on the display to show that the zone is

bypassed. If a zone is open (e.g., door with door contact is open), the keypad will display “Zone Name”

O”. If you bypass the open zone, a “B” will replace the “O”.

4. To unbypass a zone, enter the two-digit number of the zone(s) to be bypassed (01-34). You can

also use the keys to find the zone, and then press to select the zone. The “B” will

disappear from the display to show that the zone is no longer bypassed.

5. To exit bypassing mode and return to the Ready state, press .

Activating All Bypassed Zones

To remove bypass (all zones):

1. Press , then your [access code] (if necessary).

2. Press .

3. To exit bypassing mode and return to the Ready state, press .

Recalling Bypassed Zones

To recall the last set of bypassed zones:

1. Press , then your [access code] (if necessary).

2. Press .

3. To exit bypassing mode and return to the Ready state, press .

Bypass Group

A Bypass Group is a selection of zones programmed into the system. If you bypass a group of zones

on a regular basis, you can program them into the Bypass Group, so that you do not have to bypass

each zone individually every time. Only one Bypass Group can be programmed.

NOTE: If a group has already been bypassed before programming a Bypass Group, you will be

unable to recall that group after programming the new group.

To program a Bypass Group:

1. Press , then your [access code] (if necessary).

2. Enter the two-digit numbers (01-34) of the zones to be included in the Bypass Group or

use the keys to find the zone to be included in the bypass group, then press

to select the zone.

3. To save the selected zone into the group, press .

4. To exit bypassing mode and return to the Ready state, press .

NOTE: If an access code is required to enter bypassing, only the Master Code and codes with

Supervisory enabled can set the Bypass Group.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

No comments

DSC PowerSeries Self Contained Wireless Alarm System User's Guide Page 9