42
[804] PC5132 Wireless Expansion Programming
Please refer to your PC5102/PC5132 Installation Manual for programming locations and instructions.
NOTE: The LINKS2X50 module has not been investigated by
UL.
Special Installer Functions
[901] Installer Walk Test Mode Enable / Disable (Section 5.30 “Walk Test (Installer)” )
[902] Module Supervision Reset (Section 2.8 “Removing Modules” )
[903] Module Supervision Field (Section 2.7 “Supervision” )
[904] Wireless Module Placement Test
For more information, please refer to your PC5102/PC5132 Installation Manual
• Select the module / transmitter (zones 01-32). • Press [#] to Cancel.
Placement Led Keypad LCD Keypad Bell / Buzzer
Good Light 1 ON Steady “GOOD” 1 Beep / Squawk
Bad Light 3 ON Steady “BAD” 3 Beeps / Squawks
[990] Installer Lockout Enable
(Section 5.29 “Installer’s Lockout” )
[991] Installer Lockout Disable (Section 5.29 “Installer’s Lockout” )
[993] Restore Alternative Communicator to Factory Default Programming
(Section 5.28 “Resetting Factory Defaults*” )
[995] Restore Escort5580 to Factory Default Programming (Section 5.28 “Resetting Factory Defaults*” )
[996] Restore PC5132 to Factory Default Programming (Section 5.28 “Resetting Factory Defaults*” )
[997] Restore PC5400 to Factory Default Programming (Section 5.28 “Resetting Factory Defaults*” )
[998] Restore PC59XX to Factory Default Programming (Section 5.28 “Resetting Factory Defaults*” )
[999] Restore PC1555MX to Factory Default Programming (Section 5.28 “Resetting Factory Defaults*” )
Comments to this Manuals