DSC PK5590CL Installation Guide download pdf (Page 1)

PK5590CL Color Touchscreen Security Interface

Installation Guide

Touch-sensitive Colour LCD Display. Compatible on partition 1 of single-partition PowerSeries control panels.

The PK5590CL Touchscreen is a touch-sensitive color LCD Interface. This

keypad provides interactive operation for the User of PowerSeries alarm pan-

els (programmed for partition 1).

IMPORTANT:

• Alarm Panel programming must be performed with a PowerSeries

Keypad. The PK5590CL is intended for User programming functions

and operations.

• This Installation Guide shall be used in conjunction with the

CONTROL PANEL Installation Manual to which this equipment is

connected.

• This device is powered from a Limited Power supply. The wiring

and/or cables used to connect the PK5590CL Touchscreen shall be

insulated with PVC, TFE, PTFE, FEP, neoprene or polyimide.

• Refer to the associated User Guide and Alarm Panel installation

manual for additional information.

Specifications

Operating Voltage Range..............................9.5 - 24.0 VDC

Current Consumption...................................320 mA (max.)

Operating Temperature Range......... 14°-122°F(-10°+50°C)

Humidity ........................... 85%, RH non-condensing (max)

Figure 1, Front View

Out of the Box

 Touch Panel Display............................................. Qty 1

 User Guide........................................................... Qty 1

 This Installation Guide ......................................... Qty 1

Figure 2, Back View

Installation

1. Select a mounting location in the drywall between two studs.

Ensure that there is at least 1.5” clearance from the outer edge of

the back box and the nearest stud.

2. Cut a hole in the drywall using the template provided (Fig 3).

3. Route the 4-conductor keybus wire out from the wall.

NOTE: Use 22AWG wire only (9.5VDC min. required for Touchscreen).

4. Connect the Programming Keypad (PK5500) to the keybus and

program Panel as indicated (see Programming). Do NOT remove

the keypad when programming is completed.

5. Remove the front bezel from the PK5590CL. Insert a small slotted

screwdriver between the cover and plastic backplate and gently

pry apart exposing screws for the drywall tabs.

6. Enter [,][8] Installer Code [902]. Quickly remove Programming

Keypad and install the PK5590CL described in Step 7 (This must

be done within 30 seconds.

7. Connect the four Keybus wires to the terminals on the back of the

unit in the locations indicated.

8. Position the unit in the wall cut out and secure using the two

mounting screws and drywall tabs.

9. Replace the front bezel by snapping in place.

10. Verify Correct Operation. Refer to the PK5590CL User Guide.

NOTE:

Auto-arming is not supported on this command output panel.

Function Key 1 is used for Output Command 1, Function Key 2 is used for Command Output 2.

Drywall Tabs

4-wire Keybus Connection

1 2

Summary of Contents

Page 1 - Installation Guide

PK5590CL Color Touchscreen Security InterfaceInstallation GuideTouch-sensitive Colour LCD Display. Compatible on partition 1 of single-partition Power

Page 2 - Mounting Hole Template

Figure 3 Mounting Hole Template FCC Compliance StatementCaution: Changes or modifications not expressly approved by Digital Security Controls could vo