DSC ESCORT558O Instruction Manual download pdf (Page 8)

If the alarm was unintentional, notify your monitoring station and/or the local authorities

immediately to prevent an unnecessary response.

You can determine the source of an alarm by following the instructions in the “Alarm Memory”

section of this manual. Once the source of the alarm has been corrected, your system can be

armed again.

Alarm Memory

Your system will record in its memory alarms that occurred while the system was armed. If an alarm

occurred while the system was armed, the system will announce this message when the system is

disarmed:

“There are {number} alarms in memory, Zones {number}”“There are {number} alarms in memory, Zones {number}”

“There are {number} alarms in memory, Zones {number}”

To review the Zones that went into alarm, press [ ]. The system will announce

“For Alarm Memory press [3]”“For Alarm Memory press [3]”

“For Alarm Memory press [3]”

Press [3] and the system will indicate the zones in Alarm Memory with messages similar to the

following:

“There are {number} alarms in memory, Zones {number}.“There are {number} alarms in memory, Zones {number}.

“There are {number} alarms in memory, Zones {number}.

To exit press [#]”To exit press [#]”

To exit press [#]”

When finished reviewing the zones in alarm memory, press the [#] Key to return to the other system

status messages.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

No comments

DSC ESCORT558O Instruction Manual Page 8